Pentachlorophenol adsorption and desorption characteristics of granular activated carbon-I. Isotherms

The adsorption/desorption of pentachlorophenol (PCP) with Calgon F300 granular activated carbon (GAC) was studied and modelled. A modified Radke-Prausnitz (1972) isotherm model, incorporating a temperature- and pH-dependent proportionality constant, was found to best describe the observed PCP adsorption and desorption. The modified isotherm is valid in the ranges 4 ≤ pH ≤ 11 and 10 ≤ T ≤ 60°C. The activation energy of PCP adsorption was calculated to be 5.2 kJ/mol. At 30°C, PCP adsorbed strongly, and the rate of subsequent desorption was very low. However, the amount of PCP desorbed could be increased significantly by increasing the temperature to 60°C.     

Uptake of arsenic by New Zealand watercress (Lepidium sativum)

Watercress (Lepidium sativum) is consumed as a vegetable, especially by the indigenous community in New Zealand. An investigation was carried out on the accumulation of arsenic by watercress, following earlier reports of inordinate arsenic concentrations in some aquatic macrophytes collected from the Waikato River, North Island, New Zealand. The Waikato River and some other aquatic systems in Taupo Volcanic Zone, New Zealand have elevated arsenic concentrations due to geothermal activity. Watercress, river water and sediment samples were collected from 27 sites along the Waikato river and analysed for arsenic. Greenhouse trials with watercress grown in beakers containing added arsenic were conducted to confirm the ability of this species to accumulate arsenic. At a number of sites, the concentration of arsenic in both the water and the watercress samples exceeded the World Health Organisation (WHO) limit for drinking water (0.01 mg l(-1)) and foodstuffs (2 mg kg(-1) on a fresh weight basis). The average leaf and stem arsenic concentrations were, respectively, 29.0 and 15.9 mg kg(-1) on a fresh weight basis. Plants grown in solutions of >0.4 mg l(-1) arsenic concentration had fresh weight arsenic concentrations above the WHO limit. Despite these higher concentrations, arsenic levels in plants grown under greenhouse conditions were approximately fivefold lower than in plants growing in the Waikato River, possibly because under natural conditions, the watercress is rooted in sediment containing on average approximately 35 mg kg(-1) arsenic. It is recommended that watercress from the Waikato River, or other areas with elevated water arsenic concentrations, should not be consumed.     

Glass with hydration-induced compressive stress profiles

A novel potassium phospho-aluminosilicate composition is described that can be strengthened by water vapor to achieve deep compressive stress (CS) profiles. Water vapor treatment at (A) 85°C and 85% relative humidity for 40 days results in a CS of 389 ± 20 MPa and a compressive depth of layer (DOL) of 18 ± 2 μm. When treated at (B) 160°C and 0.1 MPa for 7 days, a CS of 245 ± 20 MPa and a DOL of 40 ± 2 μm is achieved. Glasses with hydration-induced stress profiles can provide high retained strength following flaw introduction compared with ion-exchanged soda-lime silicate glass. Sample treatment B also has an exemplary Vickers indentation cracking threshold value greater than 20 kgf. The hydration profile determined by secondary ion mass spectrometry (SIMS) is shown to closely match the stress profile for these samples. SIMS analysis also shows that the depth of water enrichment correlates well with the depletion depth of phosphorus. The high tendency towards water-induced strengthening for this new type of glass even enables self-strengthening by the generation of a near-surface CS profile following exposure to ambient conditions.     

Water Quality Improvement by Combined UF,RO, and Ozone/Hydrogen Peroxide System (HiPOx) in the Water Reclamation Process

Conventional water reclamation processes, such as membrane bioreactors, are not always effective in removal of pharmaceuticals and personal care products (PPCPs), endocrine disrupting chemicals (EDCs) and/or N-nitrosodimethylamine (NDMA), even with the reverse osmosis (RO) membrane process. A study was conducted, at a NEWater factory in Singapore, to compare a conventional ultrafiltration (UF) membrane /RO treatment process with a treatment train having the HiPOx unit, an advanced oxidation process (AOP), which was installed between the UF and the RO unit operations. By incorporating the HiPOx into the UF/RO treatment process, following results were observed; 1) increased removal of PPCPs, EDCs and NDMA, 2) improvement in ultraviolet transmission (UVT) of the RO permeate, 3) enhanced removal of TOC and color, and increased UVT of the RO brine, 4) suppression of the increase in the RO transmembrane pressure by organic fouling.     

Improved additive manufacturing of silicon carbide parts via pressureless electric field-assisted sintering

High solids loading silicon carbide (SiC)-based aqueous slurries containing only .5 wt. % organic additives were utilized to create specimens of various geometries via an extrusion-based additive manufacturing (AM) technique. Pressureless electric field-assisted sintering was performed to densify each specimen without deformation. The combination of these techniques produced parts with >98% relative density despite containing only 5 wt.% oxide sintering additives. After sintering, specimens contained only the α-SiC and yttrium aluminum perovskite phases. This suggests the evolution of a nonequilibrium yttrium aluminate phase, as well as transformation from β-SiC to α-SiC. The fabrication method presented in this work has advantages over other AM techniques commonly used with SiC, because it does not require significant organic additives nor additional postprocessing steps such as chemical vapor infiltration or polymer impregnation and pyrolysis.     

Herpes simplex virus-2 transmission probability estimates based on quantity of viral shedding

Herpes simplex virus (HSV)-2 is periodically shed in the human genital tract, most often asymptomatically, and most sexual transmissions occur during asymptomatic shedding. It would be helpful to identify a genital viral load threshold necessary for transmission, as clinical interventions that maintain viral quantity below this level would be of high utility. However, because viral expansion, decay and re-expansion kinetics are extremely rapid during shedding episodes, it is impossible to directly measure genital viral load at the time of sexual activity. We developed a mathematical model based on reproducing shedding patterns in transmitting partners, and median number of sex acts prior to transmission in discordant couples, to estimate infectivity of single viral particles in the negative partner''s genital tract. We then inferred probability estimates for transmission at different levels of genital tract viral load in the transmitting partner. We predict that transmission is unlikely at viral loads less than 10⁴ HSV DNA copies. Moreover, most transmissions occur during prolonged episodes with high viral copy numbers. Many shedding episodes that result in transmission do not reach the threshold of clinical detection, because the ulcer remains very small, highlighting one reason why HSV-2 spreads so effectively within populations.     

The Flexible Rare Event Sampling Harness System (FRESHS)

We present the software package FRESHS (http://www.freshs.org) for parallel simulation of rare events using sampling techniques from the ‘splitting’ family of methods. Initially, Forward Flux Sampling (FFS) and Stochastic Process Rare Event Sampling (SPRES) have been implemented. These two methods together make rare event sampling available for both quasi-static and full non-equilibrium regimes. Our framework provides a plugin system for software implementing the underlying physics of the system of interest. At present, example plugins exist for our framework to steer the popular MD packages GROMACS, LAMMPS and ESPResSo, but due to the simple interface of our plugin system, it is also easy to attach other simulation software or self-written code. Use of our framework does not require recompilation of the simulation program. The modular structure allows the flexible implementation of further sampling methods or physics engines and creates a basis for objective comparison of different sampling algorithms.     

Pheromone responsiveness is regulated by components of the Gpr1p‐mediated glucose sensing pathway in Saccharomyces cerevisiae

Many fungi have evolved mechanisms to assess environmental nutrient availability prior to the energy‐intensive process of mating. In this study, we examined one such system in Saccharomyces cerevisiae, involving a glucose‐sensing pathway mediated by Gpr1p and the pheromone‐induced mating pathway. Initially we observed that the mating pathway in MATa cells is sensitive to environmental glucose depletion. This phenomenon can be partially reversed with a high glucose spike, but not with the addition of low levels of glucose. Deletion of the low‐affinity glucose receptor, Gpr1p, eliminated this glucose‐induced recovery of pheromone responsiveness. We then determined the impact of GPR1 deletion on the mating pathway and observed that, in all end points studied, the mating pathway response to pheromone is reduced in the absence of Gpr1p. Similarly, elimination of the Gα for Gpr1p, Gpa2p, resulted in reduction in pheromone sensitivity in all assays studied. The negative effect of removing Gpr1p on mating pathway activation could be recovered by overexpressing the mating receptor, Ste2p. Furthermore, Ste2p levels are reduced in the absence of glucose and GPR1. These data suggest that activity of the GPCR‐mediated mating pathway in S. cerevisiae is modulated by extracellular glucose concentrations through the only other GPCR in MATa cells, Gpr1p. Copyright © 2014 John Wiley & Sons, Ltd.     

Three-dimensional analysis of the spatial distribution of iron oxide particles in a decorative coating by electron microscopic imaging

The three-dimensional (3D) spatial structure of an iron oxide containing alkyd paint specimen has been investigated by serial block-face scanning electron microscopy (SBFSEM). The resultant images of the 3D structure clearly present the spatial distribution of the iron oxide pigment particles in the coating film and reveal the extent of aggregation of the particles in the matrix material. More than one-half of the iron oxide particles (in volume) had aggregated to form clusters of considerable sizes that follow a Gaussian spacing distribution in the measured coating film. Over 80% of the clusters have dimensions between 1.5 μm and 3.5 μm; also, pores are evident at the centres of clusters whose sizes are larger than 2 μm. The work demonstrated here reveals a new approach to fully characterize the 3D spatial structure of coatings and to explore their correlations with the performance of the materials.